Wall Oven and Double Oven Repair in Ventura, CA
A built-in oven has the same heating parts as a range, plus a few that exist only because it lives inside a cabinet. Those extra parts cause most wall oven calls.

Our wall oven repair Ventura visits cover built-in, single and double ovens from all major brands.
Updated October 2026 | How our content is written

Parts Only Wall Ovens Have
- Cooling fan. It pulls air across the electronics and out the vent under the door. When it fails, the control overheats and the oven shuts down or throws a fault mid-bake.
- Thermal cut-out. A safety switch that opens when the cabinet side of the oven gets too hot. It often trips during or right after a self-clean cycle.
- Door lock motor. It latches the door for self-clean. If it stalls halfway, the door stays locked or the oven refuses to start.
- Shared controls. On many double ovens one panel runs both cavities, so a single board or touchpad fault can take out the upper and lower oven together.
Why the Oven Usually Has to Come Out
Most wall oven parts sit behind the unit or on top of it, not behind the door. The oven has to slide out of the cutout to reach them, and a double oven is heavy enough that the pull-out needs planning: floor protection, a support to rest it on, and enough slack in the wiring.
Have the model number ready before the visit. It is printed on a tag inside the door frame, and it decides which parts go on the truck.
Proving Drawer Not Warming
Many wall ovens have a warming or proving drawer underneath. When dough stops rising or the drawer stays cold, the cause is usually a failed heating element, a faulty thermostat or a loose connection at the back. The drawer runs on its own circuit within the oven, so the main cavity can still bake while the drawer does nothing. It can be checked on the same visit as the oven.
If Replacement Comes Up
Wall ovens are sold in 24, 27 and 30 inch widths, but cutout height and depth vary by brand and year. A new oven that does not match the old opening means cabinet work, which is a strong reason to repair a built-in that still has parts available. Measure the cutout, not the oven front, before planning a swap.
Common Questions
Why did my wall oven die after self-clean?
Self-clean heat often trips the thermal cut-out or blows a thermal fuse. Both can be tested and replaced, and the cooling fan should be checked at the same visit.
Can one cavity of a double oven be fixed without touching the other?
Yes, when the fault is an element, sensor or igniter in that cavity. If the shared control is at fault, both are affected by the same repair.
Is the fan noise after I turn the oven off normal?
Yes. The cooling fan keeps running until the electronics cool down. A fan that never runs, or one that rattles, is the one to worry about.
Book a Visit for Your Oven
Call with the brand, the model number and what the oven is doing, and ask what the technician found.
Wall ovens are built into your cabinets, so the repair has to protect the kitchen around them. We support the unit properly before sliding it out, and while it is open we also check the cabinet wiring and the junction box.
What Wall Oven Repair Costs in Ventura
Wall oven repairs usually run between $250 and $1,200 for parts and labor. Built in models use pricier parts than freestanding ranges, and some jobs need two technicians to move the unit safely.
- Heating element replacement: $400 to $1,200
- Control board replacement: $300 to $900
- Door latch or hinge repair: $250 to $550
- Temperature sensor replacement: $200 to $350
We test the failed part first and quote the full price before any work starts, so the number we give you is the number you pay.
Wall Oven Repair Across Ventura County
Built in single and double wall ovens are standard in many remodeled kitchens in Ventura, Camarillo, Ojai and Santa Paula. Because the oven sits inside cabinetry, many repairs mean sliding the unit forward to reach the wiring, the cooling fan or the control board. Plan for clear access to the oven and a protected floor in front of it.
Common Wall Oven Repair Problems We Diagnose
- Error code on the display and the oven will not start
- Door stays locked after a self clean cycle
- Cooling fan noise or fan that never stops
- Upper or lower oven not heating
- Touch pad keys not responding
Double wall ovens share one control board and often one cooling fan, so a fault in one cavity can affect both. A locked door after self clean, an error code on the display or a cooling fan that runs nonstop are the most common wall oven calls.
